Current position > Product detail
『Vortex flowmeter with temperature and pressure compensation』Related information(clamp on meter|electromagnetic meter|venturi meterrotameter|orifice meter|ultrasonic flow meter|mass flow meter|coriolis mass flow meter|coriolis flow meter|magnetic flow meter|magmeter flow meter|magflow flow meter|mag meter flow meter|electromagnetic flow meter|vortex flow meter|turbine flow meter|thermal mass flow meter|thermal flow meter|rotameter flow meter)
1. Open channel box flowmeter
2. EMERSON 8800D vortex flowmeter manual: [3]
The core content of the EMERSON 8800D vortex flowmeter manual is as follows:
1. Product Overview EMERSON 8800D vortex flowmeter is a flow measurement instrument designed based on the Karman vortex principle, suitable for measuring the volume flow of steam, gas, and liquid. Its core component is the vortex generator, which generates periodic vortices when fluid flows through it. Flow calculation is achieved by detecting the vortex frequency. The product has the characteristics of high precision, high reliability, and wide range ratio, supporting multiple output signals (such as 4-20mA, pulse, RS485, etc.), which can meet the early rolling requirements of industrial automation control covers.
2. Installation and Debugging Installation Requirements: The flowmeter should be installed horizontally or vertically (when installed vertically, the fluid should flow from the bottom to the top), avoiding strong vibration environments.
. The length of the upstream and downstream straight pipe sections must meet the following requirements: upstream ≥ 15DN, downstream ≥ 5DN (DN is the nominal diameter of the pipeline) to ensure fluid stability. The installation position should be away from local resistance components such as valves and elbows to reduce interference. Electrical connection: Before wiring, it is necessary to confirm that the power supply voltage is consistent with the rated voltage of the instrument (usually 24V DC or 220V AC). The signal line should be shielded twisted pair and laid separately in a conduit to avoid parallel with the power cable. The grounding resistance should be ≤ 4 Ω to prevent electromagnetic
III. Operation and Parameter Configuration: Set parameters such as range, unit, damping time, etc. through local buttons or upper computer software.
. Need to input fluid density, temperature/pressure compensation parameters (such as enabling temperature/pressure compensation function when measuring steam). Calibration method: Zero point calibration: performed in a static state of the fluid, ensuring that the output signal is 4mA (or set zero point value). Range calibration: Connect a known flow standard signal and adjust the instrument output to the corresponding value.4. Common faults and solutions Fault phenomenon 1: Output fluctuation when there is no flow Reason: pipeline vibration, electrical interference, or zero drift.
. Solution: Strengthen the pipeline, check the grounding, and recalibrate the zero point. Fault phenomenon 2: Low flow display. Reason: Scale formation in the vortex street, insufficient straight pipe section, or incorrect parameter settings. Handling: Clean the generator, adjust the installation position, and verify parameters such as fluid density. Fault phenomenon 3: Unstable output signal. Reason: Poor contact of signal line, fluctuation of power supply voltage or fluid pulsation. Solution: Check the wiring, secure the power supply, and install buffering devices downstream.Fifth, Maintenance and Regular Inspection: Check the electrical connections and mechanical seals every 6 months, and conduct a comprehensive calibration every 12 months.
. Cleaning requirements: For media that are prone to scaling (such as sewage), it is necessary to regularly disassemble and clean the vortex generator to avoid blockage. Storage conditions: When not in use for a