Current position > News detail
『Electromagnetic flowmeter well』Related information(clamp on meter|electromagnetic meter|venturi meterrotameter|orifice meter|ultrasonic flow meter|mass flow meter|coriolis mass flow meter|coriolis flow meter|magnetic flow meter|magmeter flow meter|magflow flow meter|mag meter flow meter|electromagnetic flow meter|vortex flow meter|turbine flow meter|thermal mass flow meter|thermal flow meter|rotameter flow meter)
1. Equipment needs to be installed on the underground filling pipeline, including flow metering, pressure monitoring, valve control, filtration, and mixing equipment, to ensure a stable and efficient filling process. 1. Introduction to flow measurement equipment: commonly used electromagnetic flow meters (using electromagnetic induction to measure the flow of conductive liquids) or ultrasonic flow meters (calculating flow velocity through ultrasonic propagation time). Function: Accurately measure the flow rate of the filling material, support dynamic adjustment of flow rate and dosage, ensure filling uniformity and quality standards
2. Introduction to pressure monitoring equipment: Pressure sensors (pressure signal blocking to electrical signal conversion) and pressure gauges (intuitive numerical display) are typical configurations. Function: Real time monitoring of pipeline pressure changes, prevention of high pressure damage or low pressure blockage problems, ensuring filling continuity. Valve introduction: such as gate valve (fully open/fully closed control), ball valve (quick switch seal), butterfly valve (simple structure and easy operation). Function: Adjust the flow rate and on/off control of rock silver, adapt to the operational needs of different filling stages, and improve system flexibility.
4. Filter Introduction: Most of them are filter type mechanical filters that intercept large particle impurities.
. Function: To prevent foreign objects from blocking the pipeline, reduce equipment wear and reduce the risk of downtime.5. Mixer Introduction: Static mixer is mainly used, with built-in components to enhance the mixing effect of materials.
. Function: Improve the uniformity of the
2. How to determine the location of the electromagnetic flowmeter well
How to determine the location of the electromagnetic flowmeter well
1. It should be kept away from strong magnetic field equipment.
.2、 Avoid places with strong vibrations and corrosiveness.
3、 Pipelines that do not allow flow interruption in the process should be equipped with shut-off valves and bypass pipelines when installing flow meters.
4、 There should also be a certain straight pipe section upstream of the flowmeter sensor, usually between 5D and 10D. 5. It can be installed horizontally, vertically, and diagonally, but it is necessary to ensure that the measuring tube is coaxial with the width of the skillful rolling process pipeline and that the measuring tube is always filled with liquid. 6. The measuring tube, housing, shielded wires of the leads, and the pipelines at both ends of the sensor must be reliably grounded and must not be shared with the grounding of other electrical equipment. This is a special installation requirement for electromagnetic flow meters.
3. What are the installation specifications for electromagnetic flow meters?
Huaian Kaikai specializes in producing electromagnetic flow meters with reliable quality and competitive prices
1. Selection of installation location: · Choose a location where negative pressure will not occur inside the measuring tube;
; ·Avoid installing in accessories of strong electrical equipment such as motors and transformers to prevent electrical interference; ·Avoid places with strong corrosive gases around the installation location; ·When meas